DIYprojects.info

Prometheus · Guest

Hello all-

We're having a little break from the heat this weekend in my neck of
the woods, so I'm contemplating firing up the forge and making myself
a few more turning tools. (I didn't realise when I made it, but a gas
forge is a bad option when the weather turns hot when compared to a
coal one, and I haven't had the fortitude to use it much this summer!)

The psuedo-Oland type tool I've got in mind (with a toolbit inserted
into the end of a bar rather than through the side) should be easy
enough, but the hook tool raises a question or two in my mind.

The way I see it, there are two ways for me to make one of these- I
can either draw out the end of a bar, chamfer it, and then fold it
over to literally make a hook, or I can just hammer the end of some
flat stock into a circle shape, drill or punch a hole in the center,
then finish forming it by countersinking before I heat treat it.

In either case, I'll probably be sharpening with a grinding point in
the die-grinder or dremel tool, but I'm just wondering if one design
would work better than the other for some reason. The material will
be 1095 high-carbon steel (also known as W1 tool steel) because that
is what I have, and it takes a nice sharp edge after hardening and
tempering.

I intend to just leave the remainder of the bar on the end of the hook
as the handle, so that I can reforge it when it eventually wears out.
It'll most likely be 3/8-1/2" thick, and about 3/4" in diameter, as
that would involve the least amount of hammering (1095 is tough stuff,
even when hot.)

So, if anyone has any preferences or thoughts about these two styles,
I'd appreciate a quick review! Either one will take some time and
effort to make properly, so I'd like to go with the best design I can.

Darrell Feltmate · Guest

Prometheus
I like to make them with inserted hooks like this
http://aroundthewoods.com/hooktool.shtml
For some using hints there are videos and stuff here
http://aroundthewoods.com/hookuse.shtml

--
God bless and safe turning
Darrell Feltmate
Truro, NS
http://aroundthewoods.com
http://roundopinions.blogspot.com

"Prometheus" <prometheus@NOSPAMcharter.net> wrote in message
news:qjrb83ljsvk2s5pca4cpg88oe1uv1cqnk6@4ax.com...

Arch · Guest

Morning Jesse,

Another way to make 'hook tools' is to grind flat stock or tool bits
etc. to shapes that are basically hooks. I like the shape of the
'Viking' for end grain. It is robust, doesn't pack the shavings and it's
easy to grind & sharpen. Look in catalogs or Soren Berger's website for
a pic. I think it is essentially a hook tool. A grinder and a few tool
bits and you have a set up for experimenting.

Hope I'm not too far off topic. You might really just want to fire up
your forge, but be careful. Someone will accuse you of inconveniently
warming the globe. :)

Turn to Safety, Arch
Fortiter

http://community.webtv.net/almcc/MacsMusings