DIYprojects.info
DIY Guides | DIY Projects | DIY forums, newsgroups



SearchSearch RegisterRegister Log in to check your private messagesLog in to check your private messages ProfileProfile Log inLog in
Bending 1.5" round stock

 
Post new topic   Reply to topic    Index -> Metalworking (rec.crafts.metalworking)
Author Message
HeavyMetal
Guest
PostPosted: Fri Jan 05, 2007 2:22 pm    Post subject: Bending 1.5" round stock Reply with quote
I need to bend a bunch of 1.5" hot rolled round stock 140 degrees. Other
than heating up with a rosebud and goin to town, any ideas that would not
over stress the bar?
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Index -> Metalworking (rec.crafts.metalworking) All times are GMT
Page 1 of 1

 

FAQFAQ  MemberlistMemberlist  UsergroupsUsergroups

Featured Site: Free Antivirus and Antispyware Info


Powered by p|-|pBB
Usenet and forums posts belong to their respective authors. Everything else is (c) 2004 - 2006 Web-S-Sense Pty. Ltd.
Terms and Conditions of Use