DIYprojects.info

Joe Bemier · Guest

Some of you might remember my neighbor - wealthy, lots of very good
tools, never really builds anything.
Anyway, last evening he dragged me over to his shop as he was having
problems with his new Stile and Rail set (Whiteside).
The Stile cutter is working fine but the rail cutter is leaving quite
a bit of burn.

I did note some very high frequency vibration when the rail cutter is
installed - not when the Stile cutter is installed.

The cutters are brand new - days old.

Frankly, I failed to correct his problem but told him I would post in
here and see if you guys had any suggestions. I'm a stair builder and
rarely use these types of cutters.

Thanks