DIYprojects.info

Mike in Arkansas · Guest

All but of couple of my upper doors are true divided lite. To make
these I purchased the freud 99-270 router bit set. For the lower doors
and drawer faces and two upper doors I was planing on flat panel
construction with the panel fitting into a grove in the rail and
stiles. The divided lite set won't make this type. It doesn't cut a
groove but a rabbit. Is it inappropriate to mount panels in a rabbit
and apply some kind of backing around the edge to hold it in just like
they were glass panels. I can't imagine why this won't work. But,
want to be sure before I mess up some expensive wood. Also, I want
things to look good and be "right". Would I be better off getting a
rail and stile set with a matching profile (its a plain cove) and go
that way?
Mike in Arkansas who is recovered from the kickback incident except for
a mighty itch near the ribs.